
Search the Community
Showing results for tags 'electrical'.
-
Hi My Hoover Nextra washer dryer has been working fine for 4 years but now after the trip switch went off, it won't fill with water (the trip switch is back on). All filters are clean as per instruction manual. Water supply and hose are fine - no kinks or blocks and the tap is on. Power supply is fine. Spin and drying cycles work fine but not wash or rinse cycles. No water enters machine at all - not the drawer or the drum. I've followed all troubleshooting tips in the manual and online. I even bought a new triple solenoid valve and replaced it but to no avail. On selecting a wash program and pressing start the "door lock light" lights up, the appropriate "time remaining light" lights up - then it just sits there for 3 or 4 minutes doing nothing then the "start" light and the "delay start" button light flash intermittently. There is nothing in the manual for this combination of lights. Also if a delay start was selected it should light up the delay time which it isn't doing. Pressing any button at this time doesn't change anything on the control panel. It's basically frozen. I'm guessing there must be an electrical fault but not at the solenoid valve - somewhere further back down the line - but how do I find out where or what is at fault? Is it worth repairing? Hoover will charge £120 for callout + extra for parts. Machine cost about £400 4 years ago. Apart from the solenoid valve is there anything else that is DIYable? Hope someone can advise... Kind Regards Andy
-
Suspected Faulty Heater On Bosch Maxx Lifestyle (Wae26470Au)
brigman posted a topic in UK Washing Machine Repair Questions
Hi All, I think I have a faulty heating element (or associated relay) on my Bosch Maxx Lifestyle (WAE26470AU). If I disconnect a specific wire on the back of the control panel the cycle seems to proceed normally, but if I leave it connected it cuts out the 240v mains circuit to which it is connected with an RCD fault half a second after the motor engages. It doesn't happen on a cold wash. Can anyone take a look at the pics (with the disconnected wire highlighted) and confirm my theory? Here's a link to the pics (link) with a description below: Front panel. Shows control panel on right hand side of detergent bays Shows the back side of the control panel from inside the washer. Orange oval highlights area of focus for picture 3. Shows the back of the control panel with the black connector (highlighted in orange) disconnected from its socket (highlighted in red). RCD faults no longer occur when this wire is disconnected. Shows the information placard on the rear of the unit Further to that, I have examined this video on how to replace the element (link) is there a specific test I can do without taking the front of the machine off to make sure I am going to order the right part(s)? I have found the element online (link), does anyone know the Bosch part number? Kindest regards, Denys