Note: The links above are needed to help keep this site running, please consider using them.
Search the Community
Showing results for tags 'whirlpool'.
Found 3 results
-
At the end of any cycle, even several minutes after the End display comes on, the door will not open (door open light does not come on). To open it I have to switch off then on again. I have just realised that probably I had the Easy Care button selected, which stops it opening until cancelled! I didn't know what this button/light meant until I looked it up.
-
Dear All I have a wirlpool AWM 7080 that has one problem. The program knob rotates himself and after 14 clicks, stops a few second and then restarts turning around. After some 1 or 2 minutes, the water pump starts for a few seconds and stops and stops the program knob for rotating and nothing else happen. If I turn off and turn on again repeats the same. Somebody tell to take out the power cord for at least 10 mints, for reset I suppose, but does not work. Can somebody help me? Best regards CPalha
-
Quite a substantial amount of water is remaining below the rubber as shown in photo. I tried to check if the three holes were blocked - they are not. Filter cleaned. All seems fine. Any suggestions?
