Jump to content
Appliance Offers
Joannamarie

Making High Pitched Squealing Noise During The Spin Cycle

Recommended Posts

I have a Hotpoint WD860 washer dryer. It's about 5 1/2 years old. Recently it has been making a very high pitched squealing noise during the spin cycle. As the spin speeds up the noise starts then fades as the spin slows. It only did it occasionally to start with on the higher spin speeds but now it's every time.

I called a local repair man. He said it was the motor bearings which were dry as the built in lubrication wasn't working properly. He tried some WD40 and said if it didn't improve I'd need a new motor unit as its a sealed unit so you can't replace the bearings. He quoted me £170 for the motor plus fitting.

The problem persisted. I decided to call Hotpoint as the manufacturer. They offered me a 1 year warrenty for £190 which would fix the fault or replace the machine if it couldn't be fixed. This seemed a good deal to me.

The Hotpoint engineer came out this morning. He says it's not the motor bearings themselves but the rubber seals protecting the motor bearings which dry out. He also squirted WD40 around then sggested I try running the machine on a boil wash. He said this would cause the rubber to expand and contract which would ease it and stop the noise.

I have done the boil wash and a couple of washes after that and so far no change. The squeal still kicks in during the spin.

Who is right? Should I be concerned about this noise? Should I get Hotpoint back to replace the motor?

Advice would be greatly appreciated!

Share this post


Link to post
Share on other sites

Book washing machine & appliance repairs Buy appliance spare parts

Note: The links above are needed to help keep this site running, please consider using them.

I would think the Hotpoint engineer is more likely to be right.

Motor bearings can make a high pitched squealing noise, though personally I would never put WD40 on them as it would tend to thin out any grease that's in there and could make them eventually run noisier. WD40 is a liquid and not suitable or designed to lubricate or even stay inside bearings.

If the noise is coming from the seal protecting the drum bearings then you can't possibly get any lubricant any where near it without stripping down the drum.

If it is the seal on the drum bearings then it may eventually stop on its own but can be put up with as it shouldn't cause a problem other than the annoyance. If eventually the drum bearings start to become noisy with a rumbling sound that's the time to get it fixed.

.


Need an engineer, or to buy appliance spare parts? Please use my affiliate links to support this forum.

Book appliance engineer | Buy your Spares (4Washerhelp)

Warning:  Read this before attempting any diy repairsNo representations or warranties are made (express or implied) as to the reliability, accuracy or completeness of advice. I can't be held liable for any loss arising directly or indirectly from the use of, or any action taken in reliance on, any information on this website, which is given free of charge and in good faith.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...