InFrance 0 Report post Posted August 13, 2018 The site is obviously more focused on electrical issues and fires than overflowing and flooding, but I was hoping for some help. I'm replacing a 20-year-old Miele dishwasher with an aqua stop mechanism by a Whirlpool WFC 3C26 P (virtually new, a gift) that has no aqua stop device. Should I simply replace the intake hose by one with an aqua stop or similar device? (There's no feedback; it operates by closing when water flows in without meeting any resistance.) I contacted Whirlpool customer service in France and asked for suggestions; they sent me the commercial spec sheet but didn't answer the question. This is more of an issue in France, where incoming water pressure is 6 bar; I've installed a reducer to bring it down to 3 bar; but it's much higher than with a cistern. Thanks for any suggestions. Share this post Link to post Share on other sites
Whitegoodshelp (Andy) 183 Report post Posted August 14, 2018 Hello, I have an article about aqua stop hoses which may answer your question? Need an engineer, or to buy appliance spare parts? Please use my affiliate links to support this forum. Book appliance engineer | Buy your Spares (4Washerhelp) Warning: Read this before attempting any diy repairs. No representations or warranties are made (express or implied) as to the reliability, accuracy or completeness of advice. I can't be held liable for any loss arising directly or indirectly from the use of, or any action taken in reliance on, any information on this website, which is given free of charge and in good faith. Share this post Link to post Share on other sites