Indesit Iwdc6105 - Filled With Cold Water After Wash Cycle
Posted 19 February 2012 - 12:46 PM
There isn't an LED display so there's no error message.
When I want to start a cycle, the 'door locked' light flashes red repeatedly (not in a pattern ie. 7 times).
I've read some of your forum and I think I need to take out the cold water lead (from top right-hand corner of back of machine) and make sure it's not blocked, should I do this?
Please help, I know very little about this sort of thing.
| Buy Appliances |
Note: The links above are needed to help keep this site running, please consider using them.
Posted 20 February 2012 - 11:46 AM
If by any chance the washer has filled up with water without being on a programme there are a couple of explanations here - Washing machine fills with water overnight or when switched off
If the article and all the other relevant ones it links to don't help I would suggest getting an engineer.
- Neilj likes this
Please consider buying spares from my 4Washerhelp links to support my sites. Prices are same as the other major spares sites but it helps keep my sites running.
- Disclaimer: You must be competent to carry out repairs, and accept responsibility for your own and other people's safety* - DIY repair safety and tips
* I use all reasonable efforts to ensure information contained on Washerhelp is correct and accurate, no representations or warranties are made (express or implied) as to the reliability, accuracy or completeness of such information. I therefore cannot be held liable for any loss arising directly or indirectly from the use of, or any action taken in reliance on, any information appearing on this website, which is given free of charge and in good faith.
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users